Tag Archives: Hydrogen Sulfide Gas Removal

How To Remove Sulfur From Hydrocarbon Gas

There is no doubt that absorption is one of the most commonly followed and simple processes that is used in water treatment, production of various specialty chemicals, separation of hydrogen sulfide gas removal of trace impurities. Though absorbents are quite commonly used, they have not yet been fully or broadly adopted when it comes to the refining of liquid carbon streams. However, when we spend some time and have a broader perspective about techniques that could help in removing sulfur and other trace impurities, there are quite a few things that fall in place. Over the years, engineers and scientists have been able to gather the right knowledge and use the right technology. This goes a long way in having the best levels of controls of the various properties of interfaces and surfaces that lead to the design of raw materials at the molecular levels. It also would be pertinent to mention here that technologies pertaining to absorption, capacity, kinetics, and selectivity also show significant improvement. Hence, there are reasons to believe that widespread usage of these technologies over the next few years and decades is very much possible according to experts. It, therefore, would be interesting to have a closer look at the above from various perspectives for the information and knowledge of our readers.

Can Olefin Character Be Preserved

If a refiner is keen on preserving the olefin character or the aromatic attributes of a stream, then it is important that the right compounds or applications be used as far as absorption is concerned. Further, such methods must ensure the h2s removal from biogas or concentrated organo-sulfur or organo-nitrogen compounds. When we use traditional methods of hydro-treating it could lead to saturation of olefins and also it could have the same impact on some types of aromatic compounds. Hence, there is a need to look at other options also. There are also situations where zeolites (which are microporous coordination polymers and activated carbons) have led to competition for the various absorption sites. This also has led to the decreased presence of the sulfur compound. But when it comes to olefins and aromatics with nitrogen, there is not much information available.

A Look At The Separation Process Overview

It would be interesting to look at the separation process. It basically uses two columns and this enables continuous absorption processing and helps to separate the contaminated feeds. One of the columns runs in the absorption mode. This column removes heteroatom compounds that are embedded in the liquid hydrocarbon stream. The other column runs through the regeneration mode, and this removes the absorbed heteroatom compounds that get regenerated in the bed.

When it is absorption mode, the feed oil moves into the column and it gets over the catalyst absorbent. When this happens, these heteroatom compounds bind themselves to the absorbent. This results in the contaminant-free oil flow out fully free from various compounds and it is well and truly a purified product in more ways than one.

When we are talking about the regeneration mode, the oil feed gets switched and moves to the fresh column. The column that is spent and impure is flushed with the help of a solvent and it leads to removal of oil that is fully residue-treated.

Contact US:

Chemical Products Industries, Inc.
Address: 7649 SW 34th St, Oklahoma City, OK
Phone: (800) 624-4356